Scott Fab Shop

01/22/2026

Made this 92 hammer spring retainer for He uses it for competition and the brass will add a little more weight to help with recoil control.

09/07/2025

KYL rack and a target backer I made out of some scrap. .official

04/09/2025

Welded up some steel targets tonight.
.official

03/21/2025

03/17/2025

Most of the time I don't have the heat running in the garage and the original door was uninsulated. I really don't like store bought doors at all so decided to make my own. Rabbited the edge of maple faced 3/4" plywood and sandwiched 1" polystyrene between them and glued it all up. Used high end weatherstripping and a brush threshold seal from. Conservationtechnology.com. Now I got a high end door that was relatively inexpensive and seals like a bank vault.

03/10/2025

dynamic just received a new valve and valve seat from Weather is gonna be nice this week for some range work.

official

03/08/2025

Before and after with a sink replacement today. Odd narrow countertop meant going to Amazon to find a narrow sink. Came out pretty good.

02/27/2025

Made this little tool to remove a valve seat in an dynamic. #

02/24/2025

Made a few drahthaar silhouettes for the chapter meeting auction this weekend.

01/20/2025

Repurposed an old mountain bike through axle today and made this binocular/weather station holder that fits into my tripod's arca clamp.

07/11/2024

Repaired the valves on this vintage State College bathroom sink recently. Parts for fixtures this old are getting harder and harder to find. I clamped the valve body in the lathe and drilled out the old valve seat. I then soldered a new one in its place saving the customer from replacing the whole fixture.

07/09/2024

Some recent work I did. A customer had purchased this antique art deco light fixture. Originally it only had one bulb and never would have provided good light for this space. I fabricated a three bulb holder for it and along with modern LEDs and a dimmer switch provides an incredibly appealing light.