The Trull Gallery

05/27/2026

Todays adventures included hanging this adjustable keyboard and monitor rack for my friends at

05/22/2026

Slowly picking away at what I'm allowed to do during construction. Yesterday the venting for our oven was finished so today I added the vent hood face. All that is left is a bit of crown molding.

05/20/2026

We want our kitchen island to have a farm table vibe and I finished the support structure today. The top may take another week so to minimize any damage in the meantime, I wrapped everything up in moving blankets. That's not exactly the look we're going for...

05/16/2026

Snuck out to add the side pieces to the breakfast bar / beverage center cabinet thingy today. A little crown molding and some v-groove on the back wall and this puppy will be complete!

05/15/2026

Getting some work done on our kitchen. Mostly Island parts, but also the side panels for our built-in breakfast bar / beverage area.

05/15/2026

I just published my latest video. This is one of the rare builds, something for our own home. I'll show you how I build this cabinet to hold our plates and wine glasses, and a few of the struggles along the way. You can see it at

In this video I’m going to show you how I built this custom cabinet that holds plates, wine glasses and more for our new kitchen.If you'd like to see more of...

05/14/2026

Today's gig - install a few curtains, a towel bar or two, then... this guy! A golf simulator in a client's home. It wasn't as bad as we thought, and its pretty cool to boot!

05/08/2026

Today's project. A new floor for this bathroom. The challenge was pulling the toilet, vanity and base molding and still finishing in one day. And no you can't have one, at least for a while. My knees need recovery time...

05/07/2026

More fun with lasers! This time a four beam laser with a pile of cool accessories. Want to learn more about it? It can be seen at https://www.youtube.com/watch?v=DvnFxt8ezL8

In this video I’m going to put the new Cigman CM-S04 Laser Level through its paces and see how well it performs.If you'd like to see more of my work or downl...

05/01/2026

I just finished the follow up video where I show you how to figure out the miter angles on weird shapes. If you'd like to check it out, it is at:

Determining Miter Angles On Odd Shaped Trim Work