Using my Incra box joint jig for some maple boxes.
03/03/2026
Using some beautiful fiddleback walnut veneer for my next project.
27/02/2026
She’s officially done and ready to be delivered. What are your thoughts on the clear resin?
25/02/2026
Using my Incra box joint jig to make a drawer box out of maple. This jig always makes ultra tight joints.
23/02/2026
The easiest way I’ve found to cut finger grooves in my boards. You just need a router and one of these bits. I find this method a lot safer than dropping the board vertically onto the bit.
20/02/2026
This base is ready for dominoes and assembly. Made out of English walnut.
19/02/2026
Resawing 8/4 walnut down to 3/4 boards. Need to sharpen my blade and make some minor adjustments on the bandsaw setup.
18/02/2026
Using dominoes for this XL butcher block glue up. Dominoes (and biscuits and dowels) help tremendously with alignment for glue ups and provide some extra strength along the seam.
17/02/2026
Routing grooves for a clips in my cabinet base sides. Z clips attach a wood countertop/tabletop to cabinets and allow for wood movement. Glueing wood straight onto cabinets would likely result in cracking over time.
16/02/2026
I had a client with these old blocks that he wanted re-flattened and re-finished to go be installed on his countertop.
13/02/2026
Second topcoat done. I’ll need 6-10 coats to build the top layer thick enough to sand and polish.
Be the first to know and let us send you an email when BocoWoods posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.
